Skip to main content

Cut Damaged Pipe Section — Repair Underground Pipe Leaks

Beginner4 hours

Part of project

Irrigation System Repair · Step 8 of 10

Helpful?

In this video

Once the damaged section of the pipe is fully exposed, use a pipe cutter or hacksaw to carefully cut out the leaking portion. Make sure your cuts are clean and as straight as possible, as this will help ensure a good seal with the new compression fitting. Cut on both sides of the damaged area to completely remove it.

80.3K views737
The Handyman

532K subscribers

View Channel

FAQs

What specialized tools are essential for irrigation system repair beyond general household tools?

You'll definitely need a good shovel for digging, especially around pipes without damaging them. A hook and pick set is invaluable for cleaning stubborn sprinkler nozzles, and an adjustable wrench will help with various fittings. Don't forget PVC primer and cement for pipe repairs, and Teflon tape for threaded connections.

My sprinkler zone isn't turning on at all. Where should I start troubleshooting?

First, verify the zone is programmed correctly on your controller and that the master valve (if you have one) is open. Then, locate the valve for the non-working zone. Manually turn the solenoid a quarter turn counter-clockwise or flip its lever to see if the sprinklers activate, which helps isolate if the issue is electrical or mechanical within the valve itself.

How can I pinpoint an underground leak without excavating my entire lawn?

Look for unusually wet or overly green spots in your yard, or areas where the grass is unusually lush. You can also listen for hissing sounds near the main line or check your water meter for continuous movement even when all water sources are off, indicating a constant flow.

What are the most important safety precautions to take when digging for underground irrigation repairs?

Always call 811 (or your local 'dig safe' number) a few days before you dig to have underground utility lines marked. Wear sturdy gloves to protect your hands from debris and tools. Dig carefully and by hand when you get close to pipes or marked lines to avoid damaging them or other utilities.

Transcript
Hide

sides make sure that I can slide this over so now I'm going to cut the pipe where I have the leak so now I cut off the piece that was right here that connection and now I'm going to slide this over and connect those two pieces okay so first I need to

Auto-generated transcript. May contain errors.