Skip to main content

Locate and Inspect Leaking Valve — Locate and Inspect Valves

Beginner4 hours

Part of project

Irrigation System Repair · Step 5 of 10

Helpful?

In this video

Locate the irrigation valve box, typically a green or black box in the ground, by observing areas with unexplained constant wetness. Open the valve box and visually inspect the irrigation valves for leaks. If a valve is leaking slowly, indicated by a small trickle of water, attempt to tighten the screws on the valve cover or manually turn the lever an additional 1/8 to 1/4 turn to ensure it's fully closed. Confirm by checking the wet area to see if the leak has stopped.

33.4K views1.7K
The Handyman

532K subscribers

View Channel

FAQs

What specialized tools are essential for irrigation system repair beyond general household tools?

You'll definitely need a good shovel for digging, especially around pipes without damaging them. A hook and pick set is invaluable for cleaning stubborn sprinkler nozzles, and an adjustable wrench will help with various fittings. Don't forget PVC primer and cement for pipe repairs, and Teflon tape for threaded connections.

My sprinkler zone isn't turning on at all. Where should I start troubleshooting?

First, verify the zone is programmed correctly on your controller and that the master valve (if you have one) is open. Then, locate the valve for the non-working zone. Manually turn the solenoid a quarter turn counter-clockwise or flip its lever to see if the sprinklers activate, which helps isolate if the issue is electrical or mechanical within the valve itself.

How can I pinpoint an underground leak without excavating my entire lawn?

Look for unusually wet or overly green spots in your yard, or areas where the grass is unusually lush. You can also listen for hissing sounds near the main line or check your water meter for continuous movement even when all water sources are off, indicating a constant flow.

What are the most important safety precautions to take when digging for underground irrigation repairs?

Always call 811 (or your local 'dig safe' number) a few days before you dig to have underground utility lines marked. Wear sturdy gloves to protect your hands from debris and tools. Dig carefully and by hand when you get close to pipes or marked lines to avoid damaging them or other utilities.

Transcript
Hide

that up see what happens cuz this lip here is ConEd it's it's shaped like this and this gasket that's on here goes down and presses and gets tighter as it the deeper it gets pushed in there what they were saying is water was gushing out this front edge and creating a puddle clearly that did not fix it there is a serious vortex

Auto-generated transcript. May contain errors.