Skip to main content

Test and Adjust Sprinkler Zones — Test Sprinkler Head Functionality

Beginner4 hours

Part of project

Irrigation System Repair · Step 4 of 10

Helpful?

In this video

Go to the irrigation controller (e.g., Toro Lawn Master II). Turn the dial to 'Manual Station' or the equivalent setting. Select a specific zone (e.g., zone 2) and activate it to run for a short period (e.g., 1 minute). Go outside and observe the sprinklers in that zone. Check that all heads pop up completely, spray correctly, and that their spray patterns are directed appropriately. If a nozzle is spraying in the wrong direction, gently grasp the nozzle and the shaft and rotate it to redirect the spray. After observing the zone, return to the controller and turn the zone off, ensuring all sprinkler heads fully retract. Repeat this process for each zone in your system.

1.2K views14
The Handyman

532K subscribers

View Channel

FAQs

What specialized tools are essential for irrigation system repair beyond general household tools?

You'll definitely need a good shovel for digging, especially around pipes without damaging them. A hook and pick set is invaluable for cleaning stubborn sprinkler nozzles, and an adjustable wrench will help with various fittings. Don't forget PVC primer and cement for pipe repairs, and Teflon tape for threaded connections.

My sprinkler zone isn't turning on at all. Where should I start troubleshooting?

First, verify the zone is programmed correctly on your controller and that the master valve (if you have one) is open. Then, locate the valve for the non-working zone. Manually turn the solenoid a quarter turn counter-clockwise or flip its lever to see if the sprinklers activate, which helps isolate if the issue is electrical or mechanical within the valve itself.

How can I pinpoint an underground leak without excavating my entire lawn?

Look for unusually wet or overly green spots in your yard, or areas where the grass is unusually lush. You can also listen for hissing sounds near the main line or check your water meter for continuous movement even when all water sources are off, indicating a constant flow.

What are the most important safety precautions to take when digging for underground irrigation repairs?

Always call 811 (or your local 'dig safe' number) a few days before you dig to have underground utility lines marked. Wear sturdy gloves to protect your hands from debris and tools. Dig carefully and by hand when you get close to pipes or marked lines to avoid damaging them or other utilities.

Transcript
Hide

manually operate each one of the zones to make sure that the sprinklers pop up and down as needed so we turn it to the manual station we pick the zone that we want in this case we'll do zone number two it'll turn the zone on and we'll go out and take a look at it and you can see that the nozzle is spraying just the way they're supposed to now if the nozzle is facing the wrong direction at this point you can just grab the nozzle and the whole shaft itself and just rotating so there's a sprays way you want it to spray and then we're gonna go shut it off and we'll make sure they pop back down as you can see they retract it just the way they're supposed to let's go take a look at the rest of them and make sure all right as you can see with this one here this one did not retract it still stayed up so we're gonna have to keep an eye on this one we'll see what happens we'll give it a spray again when it warms up a little bit and we'll see if it doesn't retract if it doesn't retract then we're gonna go ahead and replace that sprinkler head and if we do I'll make another video so you'll see how to change that now we go one more zone and we'll go test another zone to make sure oh I'm sorry I didn't take a look at it pop up just the way to suppose to each one of the nozzles is spraying where I wanted to spray in sorry we'll shut the zone or and we'll make sure that they retract the way to supposed to and that's it they retract just a way to suppose to all right so now we're all set for the for the summer to begin hello sprinklers are ready to go all right as always thanks for watching and I'll see you on the next one

Auto-generated transcript. May contain errors.