Skip to main content

Check Controller & Electrical Output — Check the Controller and Valves

Beginner4 hours

Part of project

Irrigation System Repair · Step 2 of 10

Helpful?

In this video

Begin by checking the irrigation controller, as many valve issues originate here. First, confirm that the specific zone you are troubleshooting is programmed to run. If a run-time is programmed, proceed to test the electrical output at the controller's valve terminal. Use an irrigation system tester, like the 'Tech Tool 2' shown, to verify that there is a 24-volt AC output when the zone is active. This ensures the controller is sending the necessary electrical signal to the valve.

132.9K views525
The Handyman

532K subscribers

View Channel

FAQs

What specialized tools are essential for irrigation system repair beyond general household tools?

You'll definitely need a good shovel for digging, especially around pipes without damaging them. A hook and pick set is invaluable for cleaning stubborn sprinkler nozzles, and an adjustable wrench will help with various fittings. Don't forget PVC primer and cement for pipe repairs, and Teflon tape for threaded connections.

My sprinkler zone isn't turning on at all. Where should I start troubleshooting?

First, verify the zone is programmed correctly on your controller and that the master valve (if you have one) is open. Then, locate the valve for the non-working zone. Manually turn the solenoid a quarter turn counter-clockwise or flip its lever to see if the sprinklers activate, which helps isolate if the issue is electrical or mechanical within the valve itself.

How can I pinpoint an underground leak without excavating my entire lawn?

Look for unusually wet or overly green spots in your yard, or areas where the grass is unusually lush. You can also listen for hissing sounds near the main line or check your water meter for continuous movement even when all water sources are off, indicating a constant flow.

What are the most important safety precautions to take when digging for underground irrigation repairs?

Always call 811 (or your local 'dig safe' number) a few days before you dig to have underground utility lines marked. Wear sturdy gloves to protect your hands from debris and tools. Dig carefully and by hand when you get close to pipes or marked lines to avoid damaging them or other utilities.

Transcript
Hide

if you encounter a valve that won't turn on. First, check the controller. It's worth starting by checking the obvious and simplest solutions. Starting with the controller: is the operating time set and is there a 24V output voltage at the valve terminals? If everything is OK here, move on to the valve for manual testing. Is there a water supply? If none of

Auto-generated transcript. May contain errors.