Skip to main content

Identify and Repair Leaking Sprinkler Control Valves — Repair or Replace Faulty Valves

Beginner4 hours

Part of project

Irrigation System Repair · Step 6 of 10

Helpful?

In this video

Learn to identify a leaking sprinkler control valve, which is typically buried in the ground within a valve box (often with a green lid). The primary symptom of a leaking valve is a constant drip, leading to a wet spot around the lowest sprinkler head on that particular zone, or even water running over the curb. This problem is usually caused by a worn-out diaphragm inside the valve, similar to the mechanism in a toilet's fill valve. To repair it, you will need to access the valve, remove its top section (referred to as the 'bonnet'), and replace the faulty diaphragm.

70.9K views142
The Handyman

532K subscribers

View Channel

FAQs

What specialized tools are essential for irrigation system repair beyond general household tools?

You'll definitely need a good shovel for digging, especially around pipes without damaging them. A hook and pick set is invaluable for cleaning stubborn sprinkler nozzles, and an adjustable wrench will help with various fittings. Don't forget PVC primer and cement for pipe repairs, and Teflon tape for threaded connections.

My sprinkler zone isn't turning on at all. Where should I start troubleshooting?

First, verify the zone is programmed correctly on your controller and that the master valve (if you have one) is open. Then, locate the valve for the non-working zone. Manually turn the solenoid a quarter turn counter-clockwise or flip its lever to see if the sprinklers activate, which helps isolate if the issue is electrical or mechanical within the valve itself.

How can I pinpoint an underground leak without excavating my entire lawn?

Look for unusually wet or overly green spots in your yard, or areas where the grass is unusually lush. You can also listen for hissing sounds near the main line or check your water meter for continuous movement even when all water sources are off, indicating a constant flow.

What are the most important safety precautions to take when digging for underground irrigation repairs?

Always call 811 (or your local 'dig safe' number) a few days before you dig to have underground utility lines marked. Wear sturdy gloves to protect your hands from debris and tools. Dig carefully and by hand when you get close to pipes or marked lines to avoid damaging them or other utilities.

Transcript
Hide

sprinkler repairs number one our broken valves these are devices that are buried in the ground sometimes you might see them in your yard they got the little green lid over the top of them the valve box this valve is very similar to the valve you would find in the back of your toilet that little diaphragm valve that often leaks when you hear the bathroom at night time the refilling the bowl every 15 minutes but we can have the same problem here where the diaphragm in this valve wears out and it's constantly dripping water you don't see anything at the valve itself the problem will arise or show itself at the lowest sprinkler on that zone so this sprinkler or this valve controls five or six sprinkler heads the lowest sprinkler head would always be Weeping Water so you'll get a wet spot around that sprinkler you might see water running over your curb chances are you've got a diaphragm that needs to be replaced it's a fairly simple repair it's not too difficult we removed the top which we call the Bonnet of the valve and replace the diaphragm uses it can be taken care of within 1 hour

Auto-generated transcript. May contain errors.