Skip to main content

Fill Tank, Check for Leaks, and Power On — Fill the New Water Heater

Intermediate2 mins

Part of project

Water Heater Installation · Step 10 of 13

Helpful?

In this video

Before turning on the power, it's crucial to fill the water heater tank completely with water. To do this, open a hot water faucet somewhere in the house (e.g., kitchen or bathroom sink) to allow air to escape from the tank. Then, slowly open the cold water supply valve to the water heater. Wait for a steady stream of water to flow from the open hot water faucet, indicating that the tank is full and all air has been purged. Close the hot water faucet. Carefully inspect all water line connections for any leaks. Once the tank is full and there are no leaks, restore electrical power to the water heater at the circuit breaker or dedicated switch. Listen for a slight 'hissing' sound, which indicates the heating elements have activated. The temperature can be adjusted later via a panel on the side of the unit, but it's often best to leave it on the factory setting initially.

68.3K views711
replumb

733K subscribers

View Channel

FAQs

Do I need specialized tools beyond basic plumbing gear for this project, and which ones are essential?

Yes, beyond basic wrenches and screwdrivers, you'll need large pipe wrenches (like the TradesPro 14 in. HD Pipe Wrench) for stubborn connections. A hand truck (like the Milwaukee 800 lbs. D-Handle Hand Truck) is crucial for safely moving heavy old and new units. For gas heaters, a gas leak detector or a soap solution for testing connections is also essential.

How much time should I realistically budget for a DIY water heater replacement, and is 'intermediate' difficulty accurate?

Budget at least a full day, and potentially two, as stated, especially if you encounter unexpected issues like corroded pipes or need to make trips for additional parts. The 'intermediate' difficulty is accurate because it combines plumbing, potential gas or electrical work, heavy lifting, and strict adherence to safety and code requirements, making it more complex than basic household repairs.

Transcript
Hide

it up all right it's all wired up so we're going to go ahead and turn the water back on and we'll bleed the air out and see if you got any leaks we've got a water here pill down I haven't seen the leaks yet so that's good we do need to put a pipe on the overflow there the the blow-off valve right the tank it's too much pressure in it it will release the pressure here it's you're meant to put a pipe on here like so then we'll blow it off within a few inches of the ground so I'm using the one off the old water here that way it does blow it off it will end up down here in the pan they're going to slow it all over the room okay yeah we've got it all full so I'm gonna go ahead and turn it on if you listen for

Auto-generated transcript. May contain errors.