Skip to main content

Calculate Individual Riser Height & Identify Problems — Calculate the Actual Riser Height

Beginner4 hours

Part of project

How to Measure and Plan Treads for a Split-Level Staircase · Step 3 of 8

Helpful?

In this video

Using the total rise (105 inches), the video demonstrates calculating individual riser heights. If dividing 105 inches by 14 risers, each riser would be 7.5 inches, which is acceptable for most codes. However, if a designer attempts to fit 105 inches into 13 risers, each riser would be 8.076 inches. If the maximum allowed riser height is 8 inches, this calculated riser height would be 0.076 inches too high per riser, accumulating to almost a full inch off over the entire staircase (0.076 * 13 = 0.988 inches). This discrepancy, resulting from rounding, can cause code violations or an unsafe staircase. It emphasizes the need to be precise and not round off numbers prematurely.

726 views17
Transcript
Hide

105 inches or 8 foot 9 inches. Then to figure out the individual riser height for our stairway with 14 risers, we're simply going to divide 14 into 105 inches. And that gives us a 7.5, a 7 and 1.5 inch riser height, which would be acceptable for most building codes in buildings with less than 50 occupants. But if the minimum riser measurement is 8 inches and the building designer thinks they can get away with 13 risers because when they divide 13 into 105 inches, they get 8.076 inches. And if they want to round that number off to the nearest inch, that's going to be 8 inches. And this is where the problem starts. And yes, I've had this happen to me plenty of times when I was building stairs for large track home builders who needed to make these measurements work even when they didn't. Now for those of you who understand enough about math can figure out that if we multiply 0.076 times 13, we're going to end up with 0.98 or almost 1 inch. However, whether or not that would be a problem or not, I believe it up to you. I just wanted to make you aware of it as a home builder contractor or someone who's going to be assembling the stairs for measurements that are on the plants, suggesting that the individual risers are too close to the maximum rise required by your local building codes.

Auto-generated transcript. May contain errors.