Skip to main content

Attaching Treads and Risers to Stringers — Assemble Alternating Tread Stair Kit

Beginner8 hours

Part of project

How to Install an Alternating Tread Stair Kit · Step 3 of 7

Helpful?

In this video

The presenter demonstrates the assembly process, which involves attaching the wooden treads and risers to the pre-cut stringers. He uses an impact driver to secure the wooden components with screws. The video shows him working on the stairs from the bottom up, attaching each tread and riser in sequence. A measuring tape is used to confirm the rise of approximately 7.5 inches and the tread run of 11.5 inches, highlighting that these dimensions conform to standard building codes.

25.1K views558
Transcript
Hide

and the results are stunning. We have a set of stairs that are three foot wide. When it comes to your actual rise and run, you can see we got about seven and a half inch rise and about 11 and a half inch tread. So that's going to be perfect to suit code in most areas. You gotta check out the barn kits from Best Barnes. Seriously, everything's already in the kit ready to go. All you have to do is put it together and you can follow the instructions that came with the kit or check out my video on this specific barn and I'll show you step by step how I'll put it together. You definitely can't go wrong with a barn kit from Best Barnes. I was extremely blown away by the quality of the stair kit. Everything went together really nice and after it was all said and done,

Auto-generated transcript. May contain errors.